[Lightning Systems]
[Cable, Rods]
[Concealed Systems]
[Chimney Rods]
[Grounding]
[Connectors]
[Bolt Tension]
[Surge Arrestors]
[Decorative]
[Instructions]
[Instructions Pg 2]
[Contact Info]
[Facts I]
[Facts II]
[Facts III]

Lightning Rods and Accessories

ENTER HERE

Bolt Tension Connectors, Cross Runs (3-Way) Connectors, Pipe Clamps, Water Service

Bolt Tension Connectors are the best to use. All connections must be able to withstand a 200 pound pull test.  All parts are certified by Underwriters Laboratories and approved by NFPA (National Fire Protection Association) and LPI (Lightning Protection Institute)

#EEBT End to End Bolt tension brass connectors.  $8.30
#EEBTA
End to End Bolt tension in Aluminum  $6.05

#297 Parallel Connector Bronze  $6.95
#A297 Parallel Connector Aluminum  $5.30

#F6 3-Way Cross Run Clamp Bolt Tension Bronze.  $13.20
#AF6
Aluminum $8.05  These are great to use as a Tee splice also.

#C3 Bronze Pipe Clamp used to connect to your electrical service, antenna or gas service. Fits up to 1/ 1/2 inch pipe. $13.70
#AC3 Aluminum
Pipe Clamp  $7.90

#C4 Large Bronze Pipe Clamp. Fits up to 2 inch pipe.  $17.40
#AC4
Aluminum  $9.95

#SCWS Sill Cock Water Service used to connect ground cable to outside water faucet if water supply is copper at that source. You only need to ground to one outdoor water faucet.  $18.40

You can see the heavy duty quality of our materials compared to other companies if you shopped around, that is why our prices may be a little higher. You get what you pay for. Raw bronze and copper materials are getting very expensive per pound.

If you need help in designing or laying out your lightning protection system, give us a call. We have two PDF instruction packets we can e-mail to you and you can also fax us drawings and we will design a system that works for you. Also, remember to tie in your outside water faucet if you have copper plumbing at that source.

PREVIOUS PAGE
Crimp Connectors

NEXT PAGE
Surge Arrestors